Damp footwear does two things: it stays cold, and it starts to smell. This 250-watt electric shoe dryer addresses both, pairing forced warm air with a separate ozone cycle so shoes come back dry and fresh rather than merely dry. The drying side uses forced blowing air held at a constant 95 to 131 degrees Fahrenheit. That controlled band is warm enough to pull moisture out efficiently but stays well short of the heat that damages footwear, so boots worn through rain can be turned around without punishing the material. The ozone function runs on its own switch and works on what heat alone leaves behind, breaking down the residue responsible for bad smells and other harmful elements trapped inside the shoe. Heat and ozone can be turned on together or independently, depending on whether the load is simply wet or genuinely stale. A 180-minute timing function sets the duration in advance, so a cycle can be started at night and left to finish while everyone sleeps, and overheat protection guards the element for the whole run. Four ports handle two pairs at the same time, and the tubes extend, which lets the same dryer take gloves, hats, socks and similar garments instead of footwear only. Construction is PP fiberglass and ABS, chosen to tolerate sustained warm air, and the 5.5-pound body stands 20.5 inches tall on a 15 by 10 inch base with a 13.5-inch lower tube. It is light and compact enough to store on a shelf, installs without tools, and runs on 120-volt 60-hertz household power.